Demand test descriptions and error codes - Avaya Support

Table 305: SAKI Sanity Test (#53) 2 of 3
Error
Code
Test
Result
Description / Recommendation
SAKI Sanity Test (#53)
1005 ABORT This error applies only to DS1 interface circuit packs and DS1 media
modules. It means the DS1 interface circuit pack or media module is
providing timing for the system and, therefore, it cot be reset without
causing major system disruptions. If this is not a media gateway
system, go to Step 1. If this is a media gateway system, go to Step 2.
1. If the circuit pack needs to be reset, set synchronization to another
DS1 interface circuit pack or the Tone-Clock circuit pack and try the
command again. See SYNC (Port Network Synchronization).
2. If the DS1 Media Module needs to be reset, set the
synchronization timing source to another DS1 interface Media
Module located in the same media gateway and retest. See
Setting G700 synchronization in Maintenance Procedures for
Avaya Aura Communication Manager, Media Gateways and
Servers (03-300432).
1015 ABORT Port is not out-of-service.
1. Busyout the circuit pack or media module with
busyout board location
2. Enter reset board location
2100 ABORT System resources required for this test are not available.
1. Retry the command at 1-minute intervals up to 5 times.
2803 ABORT This error applies to IP Media Processors only. The IP interface must be
disabled before running this command.
1. Use the change ip-interfaces screen to disable the media
processor’s IP interface.
2. Enter the command again.
3. If the test passes, re-enable the media processor’s IP interface
using the change ip-interfaces screen.
2966 ABORT This error applies to TN2501 VAL boards only. An announcement
autosave is in progress on the board and the reset cot be performed at
this time.
1. Wait a few minutes, then retry the command.
2 of 3
Issue 5 May 2009 1161