Demand test descriptions and error codes - Avaya Support

Maintenance Demand Tests
NPE Audit Test (#50)
The NPE Audit Test sends a message to the circuit pack to update the network connectivity
translation for all the Network Processing Elements (NPEs) on the circuit pack.
This test runs on the following maintenance objects:
● -BD (Announcement circuit pack)
● ATM-TRK (Circuit Emulation Service Circuit Pack)
CAUTION: Though
● BRI-BD (ISDN-BRI Line Circuit Pack)
● CO-BD (Central Office Trunk Circuit Pack)
● DS1-BD (DS1 Interface Circuit Pack)
● MAPD-BD (MAPD Interface Circuit Pack)
● MG-ANA (Analog Media Module)
● MG-BRI (BRI Trunk Media Module)
● MG-DCP (Digital Line Media Module)
● MG-DS1 (DS1 Interface Media Module)
● MG-IAMM (Integrated Analog Media Module)
● M/T-BD (Maintenance/Test Circuit Pack)
● RC-BD (Radio Controller Board)
● TBRI-BD (ISDN Trunk-Side BRI Circuit Pack)
● UDS1-BD (UDS1 Interface Circuit Pack)
● XXX-BD (Common Port Circuit Pack/Media Module)
! CAUTION:
normally nondestructive, this test could unintentionally tear down an
active call if the internal software tables are corrupt.
Table 302: NPE Audit Test (#50) 1 of 2
Error
Code
None
2100
Test
Result
Description / Recommendation
ABORT System resources required for this test are not available.
1. Retry the command at 1-minute intervals up to 5 times.
1154 Maintenance Alarms for Communication Manager, Media Gateways and Servers
1 of 2