Demand test descriptions and error codes - Avaya Support

SPID Facility Test
BRI-SET, Various Adjuncts
This test verifies the wiring and operation of the signaling link between the switch and a
endpoint or adjunct on a BRI interface. This test is not executed from the administration
terminal, but rather is executed by using a BRI test set equipped with a display. The test set
may replace the BRI set, ASAI or Avaya adjunct under test by plugging it into the same jack or
by bridging it onto the wiring at some point between the switch and the endpoint (or adjunct),
thereby creating a pseudo-BRI multipoint configuration.
When plugged into the port in this mer, the test set establishes a signaling link connection with
the switch and attempts to complete Service Profile IDentifier (SPID) initialization by using the
Service SPID administered for the system (see the System Maintenance Administration
screen). If the test set displays the correct administered port address for the endpoint or adjunct
under test, the test passes (see Table 63: Service SPID Display). If after one minute nothing is
displayed on the test set, the test fails.
Table 62: SPID Facility Test 1 of 2
Test
Result
Description / Recommendation
FAIL No response is received from the endpoint.
1. Check the physical wiring between the switch and the endpoint or adjunct.
2. If test continues to fail, escalate the problem.
FAIL Display does not match administered port address for the endpoint or adjunct.
1. Change station administration for endpoint or adjunct to match displayed port
address.
2. If test continues to fail, escalate the problem.
1 of 2
Issue 5 May 2009 233