Demand test descriptions and error codes - Avaya Support

Maintenance Demand Tests
● TONE-PT (Tone Generator)
Table 318: Tone Generator Crosstalk Test (#90) 1 of 2
Error
Code
Test
Result
Description / Recommendation
ABORT Internal system error
1. Retry the command at 1-minute intervals up to 5 times.
1001 ABORT The system was not able to put the tone generation facility in the
appropriate mode to test it.
1. Retry the command at 1-minute intervals up to 5 times.
1002 ABORT The system could not allocate time slots for the test connection. This can
happen when the system is heavily loaded.
1. If the system is not heavily loaded, test the TDM-BUS with
test tdm port-network P.
1412 ABORT This test does not run on media modules or media gateways. Ignore
2000 ABORT Response to the test request was not received within the allowed time.
1. Retry the command at 1-minute intervals up to 5 times.
2100 ABORT Could not allocate the necessary system resources to run this test.
1. Retry the command at 1-minute intervals up to 5 times.
FAIL The Tone Generator could be defective. In a port network with more than
one IPSI or Tone-Clock circuit pack, the system will attempt to move the
tone generation function to the alternate one.
1. Test the IPSI or Tone-Clock circuit pack again using
test tone-clock location.
2. If the test fails again, look in the Error Log for Tone Detector circuit
pack errors. If there are Tone Detector circuit pack errors, see the
following Tone Detector documentation to resolve the errors:
● DTMR-PT (Dual-Tone Multifrequency Receiver Port)
● GPTD-PT (General-Purpose Tone Detector Port)
● CLSFY-PT (Call Classifier Port)
● ETR-PT (Enhanced Tone Receiver Port)
3. If there are no Tone Detector circuit pack errors, replace the IPSI or
Tone-Clock circuit pack. See Replacing the IPSI or Tone-Clock Circuit
Pack.
1188 Maintenance Alarms for Communication Manager, Media Gateways and Servers
1 of 2