Demand test descriptions and error codes - Avaya Support

Table 189: MMI-BD Error Log Entries 2 of 2
Error
Type
Aux
Data
Associated Test Alarm
Level
769 (g) Any MMI Update Sync
Status (#1123)
1281 (h) Any Circuit Pack Restart
test (#594)
1538 (i) Any Software detected
error
1793 (j) Any NPE/TSI Crosstalk
Test (#6)
MAJ ON
MIN ON
MMI-BD (Multimedia Interface Circuit Pack)
On/Off
Board
Recommended Action
MIN ON test board location l r
3
2049 (k) Any TSI Loop (#1108) MAJ ON test board location l r
3
2 of 2
Notes:
a. Error Type 0: run the short test sequence first. If every test passes, run the long test
sequence. Refer to each test’s description, and follow its procedures.
b. Error Type 1: the circuit pack stopped functioning or it was physically removed from the
system. The alarm logs approximately 11 minutes after the circuit pack has been removed
and/or the SAKI Sanity test (#53) fails.
If the circuit pack is in the system and the red LED is on, follow the instructions for a red
alarm in the Circuit Pack LEDs section of LED Descriptions for Avaya Aura
Communication Manager Hardware Components (03-602804).
c. Error Type 18: the circuit pack was busied out using busyout board location.
d. Error Type 217: there are more than four MMI circuit packs in the system. Remove the
circuit pack that generated the error in the error log by locating the slot indicated by the
error.
e. Error Type 257: there are transient communication problems between the switch and this
circuit pack. Execute test board location and see the repair procedures for the
Control Chel Looparound Test (#52).
f. Error Type 513: the circuit pack detected an Angel on-board hardware failure. The reported
Aux Data values correspond to the following detected errors:
4352 — External RAM error
4253 — Internal RAM error
4355 — ROM Checksum error
4357 — Instruction set error
Issue 5 May 2009 655