Demand test descriptions and error codes - Avaya Support

Communication Manager Maintenance Object Repair Procedures
Table 35: ATM Error Types 1024 - 1151 2 of 3
Error
Type
1088
1104
1089
1105
1090
1106
1091
1107
1092
1108
1093
1109
1094
1110
1095
1111
1096
1112
Description General problem
ATM-EI circuit pack received a request with an
invalid connection identifier.
ATM-EI circuit pack received a request with a
reference to an unknown VC token.
ATM-EI circuit pack did not have enough
resources (memory) for the requested operation.
Internal failure in the local protocol stack. This can
occur when the connection to the ATM switch
failed, perhaps because the:
● ATM switch rebooted
● fiber between the ATM switch and the
ATM-EI circuit pack disconnected
ATM-EI circuit pack received a request for which
the referenced VC was in the wrong call state.
ATM-EI circuit pack received a request for which
the VPI/VCI pair was invalid or out of range.
ATM-EI circuit pack received a request to add a
party to an existing VC. The add party request
failed, and a retry was not possible.
ATM-EI circuit pack in link recovery after the lower
ATM layer (Q.SAAL portion of the protocol stack)
failed. This can occur when the connection to the
ATM switch failed, perhaps because the:
● ATM switch rebooted
● fiber between the ATM switch and the ATM-EI
circuit pack disconnected
ATM-EI circuit pack received an error from the
local protocol stack for which no more detailed
cause was specified.
1102 ATM-EI circuit pack asked to create more
connections that it was capable of creating.
1103 ATM-EI circuit pack detected an illegal message
from software.
Check the Error Log for CONN-M errors for more
information.
134 Maintenance Alarms for Communication Manager, Media Gateways and Servers
Firmware-detected problems
on the ATM-EI circuit pack.
Note: Error Types 1088–1103
are reported by the board that
is originating the connection.
Error Types 1104–1119 are
reported by the board that is
terminating the connection. In
most cases, when the
terminating board reports one
of these errors, the originating
board also reports an
ATM-NTWK error for the same
event (usually with Error Type
21).
2 of 3