Demand test descriptions and error codes - Avaya Support

Maintenance Demand Tests
This test runs on TIE-TRK (Analog Tie Trunk).
Table 314: Tie Trunk EPF Test (#74) 1 of 2
Error
Code
Test
Result
Description / Recommendation
ABORT Could not allocate the necessary system resources to run the test.
1. Retry the command at 1-minute intervals up to 5 times.
1000 ABORT System resources required to run this test are not available. The trunk
may be busy with a valid call.
1. Enter display trunk-group xx to determine trunk group/
member number of the port.
2. Enter status trunk to determine the service state of the port. If
the service state indicates that the port is in use, wait until the port is
idle before retesting.
3. If the port status is active, but the port is idle (no calls), check the
Error Log for Error Type 1025. See the Error Log table for the
description of this error and required actions for this maintenance
object. The port may be locked up. The far-end may not be
releasing.
4. If the port status is idle, then retry the command at 1-minute
intervals up to 5 times.
1004 ABORT The port was seized by a valid call during the test.
1. Enter display trunk-group xx to determine the trunk group/
member number of the port.
2. Enter status trunk to determine the service state of the port. If
the service state indicates that the port is in use, wait until the port is
idle before retesting.
3. Retry the command at 1-minute intervals up to 5 times.
1005 ABORT This test is not valid for this trunk translation. Must be a type-1 standard
trunk for this test to run.
1. Check trunk configuration. If it is not a type-1 standard trunk, this
error can be ignored.
1178 Maintenance Alarms for Communication Manager, Media Gateways and Servers
1 of 2