Demand test descriptions and error codes - Avaya Support

Speech Synthesis Parameter Update Test (#169)
Speech Synthesis Parameter Update Test (#169)
This test updates the dual-tone multifrequency (DTMF) inter-digit time-out parameter used by
the Speech Synthesis circuit pack so that it is consistent with that specified by the server.
This test runs on S-SYN-PT (Speech Synthesis Port).
Table 357: Speech Synthesis Parameter Update Test (#169)
Error
Code
Test
Result
Description / Recommendation
ABORT Could not allocate the necessary system resources to run this test.
1. Retry the command at 1-minute intervals up to 5 times.
1000 ABORT System resources required to run this test are not available. The port may
be busy with a valid call and therefore unavailable for certain tests. Wait
until the port is idle (amber LED is off) before retesting.
1. If the port is idle, retry the command at 1-minute intervals up to 5
times.
2100 ABORT Could not allocate the necessary system resources to run this test.
1. Retry the command at 1-minute intervals up to 5 times.
Any FAIL An internal system error has occurred.
1. Retry the command at 1-minute intervals up to 5 times.
PASS The DTMF inter-digit time-out parameter has been updated. User-reported
troubles should be investigated using other tests and by verifying that
other ports on this circuit pack are working correctly.
Digital Looparound Test (#171)
The Digital Looparound Test checks the data line port’s ability to transmit and receive data on
the TDM Bus. Data is sent through an available Maintenance/Test digital port over the TDM
Bus, internally looped through the data line port back onto the TDM Bus, and received again by
the same Maintenance/Test digital port.
Only one of the two digital ports on a Maintenance/Test circuit pack is used for this test. If
port 02 is in use, out-of-service, or not present, the test aborts. This test may fail if the
Maintenance/Test digital port used by the test is not functioning properly.
Issue 5 May 2009 1275