Demand test descriptions and error codes - Avaya Support

Table 382: ISDN Test Call Test (#258) 3 of 5
Error
Code
Test
Result
Description / Recommendation
ISDN Test Call Test (#258)
1116 ABORT The switch could not change the service state
1. See if calls are active. Enter status trunk grp#/mem#.
2. If a call is active, wait for the call to finish normally, or drop it by
running busyout trunk grp#/mem#. Then rerun the test.
3. If a call is not active:
ATM-BCH: Check the Error and Alarm Logs for ATM-TRK
problems and see ATM-TRK (Circuit Emulation Service Circuit
Pack).
ISDN-TRK: Check the Error and Alarm Logs for ISDN-TRK
problems and see ISDN-TRK (DS1 ISDN Trunk).
TBRI-TRK: Check the error and alarm logs for TBRI-TRK problems
and see TBRI-TRK (ISDN Trunk-Side BRI Chel).
1117 ABORT ISDN service message outstanding
1. Wait 2 minutes, then try again.
1118 ABORT Far-end of trunk is not administered
1. Check the administration of the far end of the trunk. Run
status trunk grp#/mem#.
2. Try the test again.
1119 ABORT The test call was aborted due to a normal call attempt on this trunk. The
test call will only be performed if the trunk is idle.
1. Wait for the call to finish normally, or drop it by running
busyout trunk grp#/mem#.
2. When the trunk is idle, retry the test.
1120 ABORT The trunk is in the out-of-service/far-end state.
1. Try to change the service state with Service State Audit Test
(#256).
2. Try the test again. However, the trunk may be in the out-of-service/
far-end state due to problems at the far-end switch. If that is the
case, no remedial action can be taken at this end.
1122 ABORT No test-line number for the far-end switch
1. Check the Trunk Group administration form.
3 of 5
Issue 5 May 2009 1339