Demand test descriptions and error codes - Avaya Support

Table 407: Invalid LAPD Frame Error Counter Test (#597) 2 of 2
Error
Code
Test
Result
Description / Recommendation
Packet Interface Test (#598)
Packet Interface Test (#598)
1–10 FAIL The circuit pack detects LAPD frame errors. The error code indicates the
value of the error counter.
1. Retry the command at 1-minute intervals up to 5 times.
2. If the test continues to fail, run the Packet Interface test (#598) with
test board location long.
3. If the Packet Interface test (#598) fails, see Packet Interface Test
(#598) for repair procedures.
PASS Circuit pack detects no errors.
This test checks the circuit pack’s packet bus interface. Data is sent through the bus and back to
itself. If the data received is consistent with the data sent, the test passes. The test does not run
if the specified PN’s packet bus has a minor alarm or is out of service.
This test runs on the following maintenance objects:
● ATM-EI (Expansion Interface Circuit Pack),
● ATM-TRK (Circuit Emulation Service Circuit Pack)
● CLAN-BD (Control LAN Circuit Pack)
● VAL-BD (Voice announcements over LAN Circuit Pack)
Table 408: Packet Interface Test (#598) 1 of 2
Error
Code
Test
Result
Description / Recommendation
1005 ABORT Wrong circuit pack to run this test. Internal error.
2 of 2
1 of 2
Issue 5 May 2009 1387