Demand test descriptions and error codes - Avaya Support

Table 40: Error codes and Aux Data values ATM-NTWK 4 of 6
Cause
Code/
Error
Type
Aux
Data
78 (a) AAL parameters cot be supported.
INVALID MESSAGES
ATM-NTWK (ATM Network Error)
81 (a) Invalid call reference value. This cause indicates that its sending equipment
received a message with a call reference that is currently inactive on the
user-network interface.
82 (a) Identified chel does not exist. This cause indicates that its sending
equipment received a request to use a chel not activated for the call’s
interface.
88 (a) Incompatible destination. This cause indicates that its sending equipment
received a request to establish a call with either Broadband low-layer
information, Broadband high-layer information, or other compatibility
attributes that cot be accommodated.
89 (a) Invalid endpoint reference value. This cause indicates that its sending
equipment has received a message with an endpoint reference that is
currently idle on the user-network interface.
91 (a) Invalid transit network selection. This cause indicates that a transit network
identification was received in an incorrect format.
92 (a) Too many pending add-party requests. This cause indicates a temporary
condition when the calling party sends an add-party message, but the
network rejects the message due to full queues.
93 (a) AAL parameters cot be supported. This cause indicates that its sending
equipment received a request to establish a call with ATM adaptation-layer
parameters that cot be accommodated.
PROTOCOL ERROR
Cause Codes Description
96 (a) Mandatory information element (IE) is missing. This cause indicates its
sending equipment has received a message with a missing IE.
97 (a) Message type either non-existent or not implemented. This cause indicates
that its sending equipment received a message with an unrecognized type,
either because the type is undefined, or defined but not implemented by the
cause-sending equipment.
4 of 6
Issue 5 May 2009 151