Demand test descriptions and error codes - Avaya Support

Table 287: GPP NPE Crosstalk Test (#9) 1 of 6
Error
Code
Test
Result
Description / Recommendation
GPP NPE Crosstalk Test (#9)
1 ABORT During testing of the primary information chel, system resources may
not have been available or the port may have been busy during the test.
1. Enter display port location to determine the extension of
the port.
2. Enter status station extension to determine the service
state of the port. If the service state indicates that the port is in use,
wait until it is idle.
3. Retry the command at 1-minute intervals up to 5 times.
2 ABORT System resources may not have been available or the port may have
been busy during the test.
DIG-LINE and E-DIG-ST:
1. Check if port is being used. If possible, disconnect by toggling the
disconnect button on DTDM. Retry the command after 1 minute.
WARNING: This action will drop any calls in progress.
All other Maintenance Objects:
1. Verify that the port is idle.
2. Retry the command at 1-minute intervals up to 5 times.
1 of 6
Issue 5 May 2009 1099