Demand test descriptions and error codes - Avaya Support

Maintenance Demand Tests
● DIOD-DS1 (DS1 DIOD Trunk)
Table 392: DS1 CO Trunk Dial Tone Seizure Test (#314) 1 of 3
Error
Code
Test
Result
Description / Recommendation
ABORT Internal system error
1. Retry the command at 1-minute intervals up to 5 times.
1000 ABORT The test was aborted because system resources required to run this
test were not available. The port may be busy with a valid call.
1. Enter display port location to determine the trunk group/
member number of the port.
2. Enter status trunk to determine the service state of the port. If
the port is in use, wait until it is idle before testing.
3. If the port status is active but the port is idle (no calls), check the
error log for Error Type 1025. The port may be locked up.
4. If the port status is idle, retry the command at 1-minute intervals up
to 5 times.
1004 ABORT The port was seized by a user for a valid call during the test.
1. Enter display port location to determine the trunk group/
member number of the port.
2. Enter status trunk to determine the service state of the port. If
the port is in use, wait until it is idle before testing.
3. Retry the command at 1-minute intervals up to 5 times.
1005 ABORT Incompatible configuration administered on trunk group screen.
1. Look at the Trunk Group administration form and see whether the
trunk is incoming only, port 24 on a DS1 Interface with common
control chel signaling, or an automatic CO type such as FX. Under
any of these conditions, this is a normal abort and can be ignored.
1018 ABORT Test is disabled by administration. Determine why the test has been
disabled before enabling it.
1. To enable the test, enter change trunk-group ( is the
number of the trunk group to be tested). Change the Maintenance
Test field on the screen to y.
2. Repeat the test.
1354 Maintenance Alarms for Communication Manager, Media Gateways and Servers
1 of 3