Demand test descriptions and error codes - Avaya Support

Table 371: MTP SAT Chel Local Looparound Test (#228)
Error
Code
Test
Result
Description / Recommendation
Serial Chel Local Looparound Test (#229)
Serial Chel Local Looparound Test (#229)
1000 ABORT System resources required for this test are not available.
2000 Response to the test was not received within the allowed time.
2033 Internal system error.
1. Retry the command at 1-minute intervals up to 5 times.
2034 ABORT The SAT port is busy. Background maintenance may be running.
1. .Retry the command at 1-minute intervals up to 5 times.
FAIL The PN terminal is not usable.
1. Run the test three more times.
2. If the test continues to fail, replace the PN’s Maintenance circuit
pack.
PASS The serial interface circuitry on the PN’s Maintenance circuit pack which
controls the PN-connected terminal is functioning properly. If there are
still troubles with the PN G3-MT terminal, the problem may be one of
the following:
1. The PN-connected terminal is not configured properly. The
connection between the terminal and the PN’s Maintenance circuit
pack must be set up at 9600 bps.
2. The serial link from the back of carrier A to the PN terminal may be
defective. The serial link consists of the connector on the back of
carrier A labeled TERM and the ribbon cable running to the
terminal.
3. The terminal may be defective. Try another terminal.
4. Since this test is not 100 percent accurate, there may still be
problems with the PN’s Maintenance circuit pack.
This test checks TN775D on-board circuitry associated with the serial links to the Expansion
Interface circuit packs.
Issue 5 May 2009 1305