Demand test descriptions and error codes - Avaya Support

Table 414: BRI Port Local TDM Looparound Test (#619) 2 of 2
Error
Code
BRI Port Local TDM Looparound Test (#619)
1004 ABORT The port has been seized by a user for a valid call. Enter status
station or status trunk for the station or trunk associated with this
port, and determine when the port is available for testing.
1. Retry the command at 1-minute intervals up to 5 times.
2. If the test continues to abort and the port is idle, escalate the
problem.
1005 ABORT This test is not valid for this type of translation. Ports administered as
“ASAI” or “ADJK” cot run this test, because the B-Chels associated with
the port are not used by ASAI or Avaya Adjunct Links. This error can be
ignored.
1412 ABORT This test does not run on media modules or media gateways. Ignore.
2000 ABORT Response to the test was not received within the allowed time.
1. If this result occurs repeatedly, attempt to reset the circuit pack if the
other ports are idle.
2. If this result occurs again, replace the circuit pack.
2012
2100
2103
1
2
7
8
Test
Result
Description / Recommendation
ABORT Internal system error.
Could not allocate the necessary resources to run this test.
The system could not make the conference connection for the test.
1. Retry the command at 1-minute intervals up to 5 times.
2. If the test continues to abort, escalate the problem.
FAIL 1 — TDM Looparound test failed on B1.
2 — TDM Looparound test failed on B2.
7 — Conference Circuit test failed on B1
8 —- Conference Circuit test failed on B2.
1. If the test fails repeatedly, try to reset the circuit pack if the other
ports on the circuit pack are idle.
2. If the test fails again, replace the circuit pack.
PASS The BRI Port Local TDM Looparound test passed.
2 of 2
Issue 5 May 2009 1401