Demand test descriptions and error codes - Avaya Support

Table 254: TBRI-BD Error Log Entries 2 of 2
Error
Type
Aux
Data
1794 (j) 46094 MIN ON
1795 (j) 46085 MIN ON
2305 (k) 46104 None ON
2306 (k) 46081 None ON
3330 (k) 46083 MIN OFF
3586 (l) MIN OFF
3841 (m) 4096 -
4101
3842 (n) 46095
3843 (o) 46097
Associated Test Alarm
Level
On/Off
Board
Recommended Action
Notes:
a. Error Type 0: run the short test sequence first. If every test passes, run the long test
sequence. Refer to each appropriate test’s description, and follow its recommended
procedures.
b. Error Type 1: the circuit pack stopped functioning or was physically removed from the
system. This alarm logs approximately 11 minutes after removing the circuit pack and/or the
SAKI Sanity Test (#53) fails.
If the circuit pack is not in the system, insert a circuit pack in the same slot as the error
indicates. See note (h) for additional information.
c. Error Type 257: transient communication problems between the switch and this circuit
pack. Execute test board location and refer to the repair procedures for the Control
Chel Looparound Test (#52).
d. Error Type 513: on-board hardware failure. Aux Data values correspond to the following
detected errors:
Aux Data 4352: External RAM error
Aux Data 4353: Internal RAM error
Aux Data 4355: ROM Checksum error
Aux Data 4357: Instruction set error
Use busyout board location and reset board location to reset the circuit
pack. When reset, the circuit pack executes a set of tests to detect the presence of any of
the faults listed above. Detection of one of these errors during initialization causes the
circuit pack to lock-up and appear insane to the system. See the repair procedure in Note
(b).
938 Maintenance Alarms for Communication Manager, Media Gateways and Servers
2 of 2