Demand test descriptions and error codes - Avaya Support

Maintenance Demand Tests
Table 394: Expansion Interface Reset Test (#336) 2 of 3
Error
Code
Test
Result
Description / Recommendation
1 FAIL The EI did not successfully reset.
1. If the EI circuit pack is in the PN, the PN’s Maintenance board
may be holding the EI circuit pack reset. Attempt to rectify this
condition by executing test maint P long on the
Maintenance board in the same PN.
2. If step 1 was not successful in releasing the EI circuit pack,
temporarily remove the PN’s Maintenance circuit pack.
3. Repeat reset board location.
4. If reset continues to fail, replace circuit pack.
5. Insert PN’s Maintenance circuit pack if it was removed.
2 FAIL The EI circuit pack was successfully reset, but it did not begin running
after the reset.
1. If the EI circuit pack is in the PN, temporarily remove the PN’s
Maintenance circuit pack.
2. Enter reset board location.
3. Reinsert the PN’s Maintenance circuit pack if it was removed.
1360 Maintenance Alarms for Communication Manager, Media Gateways and Servers
2 of 3