Demand test descriptions and error codes - Avaya Support

Maintenance Demand Tests
Figure 110: Loopback Points for Test #799
Table 456: Near-End External Loopback Test (#799) 1 of 2
Error
Code
Test
Result
DS1CONV
A
Test starts here
LB 1
CSU A
Description / Recommendation
2100 ABORT Could not allocate the necessary system resources to run this test.
2000 Test timed out while waiting for a response from the circuit pack.
2300 The downlink message necessary to run this test could not be sent.
2301 The timer could not be set before sending the downlink message.
1. Retry the command at 1-minute intervals up to 3 times.
2316 ABORT Fiber link is not administered.
1. Enter add fiber-link to administer the DS1 converter fiber link.
2321 ABORT DS1 facility is not busied out.
1. Busyout the DS1 facility via busyout ds1-facility.
2. If there is only one DS1 facility, busyout the DS1 converter circuit
pack via busyout board.
2332 ABORT With this system configuration, the test cot run at the far end when there is
only one DS1 facility available. Check the green LED at the face plate of
the DS1 converter circuit pack. The green LED should be on if the loop is
complete.
2500 ABORT Internal system error
1. Retry the command at 1-minute intervals up to 3 times.
1518 Maintenance Alarms for Communication Manager, Media Gateways and Servers
LB 2
DS1 Facility
CSU B
DS1CONV
B
1 of 2