Demand test descriptions and error codes - Avaya Support

Table 499: ATM Board Framer Looparound Test (#1260) 3 of 5
Error
Code
Test
Result
Description / Recommendation
ATM Board Framer Looparound Test (#1260)
1141 ABORT The Packet Interface circuit pack is out of service.
1. Resolve any PKT-INT (Packet Interface) problems.
2. Retry the command.
1144 ABRT The PPN’s packet bus has a major alarm against it. This test needs to
use the alarmed PPN’s packet bus.
1. Resolve any PKT-BUS problems.
2. Retry the command.
1394 ABORT ATM-EI: The ATM-EI board is out of service and the test cot be run.
1. Run Test #241. If it does not pass, see the repair procedures for
Expansion Interface 2-Way Transmission Test (#241).
ATM-TRK: ATM-TRK circuit pack out of service.
1. Run ATM Board Reset Test #1256. If it does not pass, see the repair
procedures for ATM Board Reset (#1256)
1395 ABORT This test cot be run on an ATM-EI circuit pack if it is part of the B-side
PNC and duplicated PNC is not enabled.
1. If this test needs to run on this ATM-EI circuit pack, enable PNC
duplication with change system-parameters duplication.
2. Prevent the system from doing a PNC interchange with
set PNC lock.
3. Repeat this test.
1407 ABORT This test cot be run on an ATM-EI board that is on the active PNC
because it cot be busied out. This error code indicates that PNC
duplication is enabled.
1. Attempt to perform a PNC interchange with
reset pnc interchange.
2. If the PNC interchange is successful, busyout the original
ATM-Expansion Interface circuit pack with busyout board
location (address of the original ATM-EI board).
3. Retry the command.
2000 ABORT Response to the test was not received in the allowed time.
1. Retry the command at 1-minute intervals up to 3 times.
3 of 5
Issue 5 May 2009 1615