Demand test descriptions and error codes - Avaya Support

Maintenance Demand Tests
Table 544: Power Supply Detection Test #(1535) 1 of 3
Error
Code
Test
Result
Description and recommendation
1000 ABORT Internal software error.
1. Retry the command.
2. Escalate the problem if the test continues to abort.
1035 ABORT The port network is not available.
1. Enter status port-network to verify that the network is not up.
2. Look for alarms against EXP-PN (Expansion Port Network),
EXP-INTF (Expansion Interface Circuit Pack), PKT-INT (Packet
Interface), etc.
3. Use the diagnostic procedures for those MOs to clear the problem.
1987 ABORT The power supply data was not valid.
1. Repeat the command at one-minute intervals 1 to 3 times.
2000 ABORT The response to a query was not received in the time allowed.
1. Repeat the command at one-minute intervals 1 to 3 times.
2029 ABORT There is a problem communicating with the environmental maintenance
firmware.
1. Run test maintenance nn
2319 ABORT The EPN is out of range.
2500 ABORT Internal system error.
1. Retry the command.
1696 Maintenance Alarms for Communication Manager, Media Gateways and Servers
1 of 3