Demand test descriptions and error codes - Avaya Support

Standby Reference Health Check Test (#651)
Standby Reference Health Check Test (#651)
This test evaluates the quality of the external synchronization timing source for a standby IPSI
or Tone-Clock circuit pack. Every administered synchronization timing source must be valid for
this test to pass. If the Tone-Clock circuit and the synchronization timing sources are in different
port networks, the EI circuit packs transport the timing sources to the tone-clock.
Note:
Note: This test only runs on the standby IPSI or Tone-Clock circuit pack in a port
network with more than one IPSI or Tone-Clock circuit pack (high- or
critical-reliability option). The Tone-Clock circuit pack must be a TN780 with
firmware 2 or higher, or a TN2182.
This test runs on the following maintenance objects:
● TDM-CLK (TDM Bus Clock)
● TONE-BD (Tone-Clock Circuit Pack)
● TONE-PT (Tone Generator)
Table 432: Standby Reference Health Check Test (#651)
Error
Code
Test
Result
Description / Recommendation
ABORT This test may already be running due to a tone-clock installation,
scheduled maintenance, alarm activity, or a demand test from another
terminal. This abort can also occur due to an internal system error.
1. Try the command again at 1-minute intervals up to five times.
1184 ABORT This test requires an external synchronization source to be administered
(DS1 primary, DS1 primary and secondary, or Stratum-3 clock).
1. Administer the external synchronization source and retry the test.
2500 ABORT Internal system error
1. Try the command again at 1-minute intervals up to 5 times.
Issue 5 May 2009 1441