Demand test descriptions and error codes - Avaya Support

Table 336: DS1 Tie Trunk Seizure Test (#136) 2 of 3
Error
Code
Test
Result
Description / Recommendation
DS1 Tie Trunk Seizure Test (#136)
1004 ABORT Far end is seizing the trunk while the test is ongoing. A glare situation is
detected.
1. Enter display port location to determine the trunk group/
member number of the port. Enter status trunk to determine the
service state of the port. If the port is in use, wait until the port is idle
before testing.
2. Retry the command at 1-minute intervals up to 5 times.
1005 ABORT Incompatible configuration administered on Trunk Group form.
1. Verify the following fields on the Trunk Group administration form:
a. Is trunk direction incoming only?
b. Is trunk outgoing type either automatic or immediate-start?
c. Is trunk the 24th port of the DS1 Interface circuit pack or media
module while common control chel signaling is specified?
2. If the trunk has been administered using the above information, this
test should abort.
1018 ABORT The test was disabled by administration. Determine why the test has been
disabled before enabling it.
1. Verify that the Maintenance Test field on the Trunk Group
administration form is n. To enable the test, change the trunk
administration and enter y in the Maintenance Test field.
2. Repeat the test.
1020 ABORT The test did not run due to an already existing error on the specific port or
due to a more general circuit pack or media module error.
1. Examine the error log for existing errors against this port or the circuit
pack or media module and attempt to diagnose the already existing
error.
2. Retry the test.
1040 ABORT The test is invalid for this trunk port because it is administered as an
access endpoint.
1. Enter display port location to verify that this port is
administered as an access endpoint. In this case the test should
abort and no action is necessary.
2 of 3
Issue 5 May 2009 1235