Demand test descriptions and error codes - Avaya Support

MAPD-BD (MAPD Interface Circuit Pack)
MO Name in Log Alarm
Level
MAPD-BD MAJ
MIN
MAPD-BD (MAPD Interface Circuit Pack)
Initial Command to Run Full Name of MO
test board location l MAPD Interface circuit pack
WRN test board location
The TN802 Multiple Application Platform (MAP-D) circuit pack allows sending voice and fax
from a Communication Manager server through the Internet to another Communication
Manager server also having this feature or to other PBXs that are equipped with the Internet
Telephony server (ITS-E).
Be sure to observe these special considerations for the TN802:
● Port alarms on this circuit pack display as “TIE-DS1” in the Alarm and Error logs.
● The reset board command reboots the MAPD PC CPU, but busyout board only
busies out every emulated port on the board.
● Switch resets that take the switch out of service for more than 20 seconds also cause the
MAPD's PC to reboot, which takes several minutes to complete.
Because of overheating, the TN802 circuit pack should not be placed directly above or below
another MAPD circuit pack.
Switch-demanded diagnostic tests on the TN802 do not run unless the Internet trunking
application is running on Windows NT, located on the circuit pack.
An uninterruptable power supply (UPS) protection is strongly recommended for a PN containing
a TN802 circuit pack.
Issue 5 May 2009 587