Demand test descriptions and error codes - Avaya Support

Maintenance Demand Tests
Table 509: ATM Board DSP Test (#1293) 2 of 2
Error
Code
Test
Result
2100 ABORT Could not allocate the necessary system resources to run this test.
1. Retry the command at 1-minute intervals up to 3 times.
2302 ABORT Inconsistent uplink message from the ATM-EI board (an unlikely event).
1. Retry the command at 1-minute intervals up to 3 times.
2500 ABORT Internal system error.
1. Retry the command at 1-minute intervals up to 3 times.
2752 ABORT The circuit pack in this location is not a TN2305 or TN2306.
XYZ FAIL There is at least one bad DSP on the board. Values are as follows:
● X indicates the number of bad talker DSPs
● Y indicates the number of bad listener DSPs
● Z indicates the number of bad Echo Canceller DSPs
1. Run the tests for the active Tone-Clock in the PN that contains the
indicted circuit pack to verify that dial-tone is supplied. Repair as
needed.
2. If the Tone-Clock is healthy, repeat the test on the circuit pack.
3. If this test continues to fail, check for service-affecting MINOR
alarms. If a MINOR alarm is raised for Error Type 2817 or 2818,
replace the circuit pack.
4. If a WARNING alarm is raised, this is a non-service-affecting error.
The circuit pack can still process calls.
XYZ PASS The test passed for some or all DSPs depending on XYZ values. XYZ
indicates the number of talker, listener and echo-canceller DSPs for which
the test passed, respectively.
0 NO
BOARD
Description / Recommendation
See NO BOARD for the repair procedures.
1634 Maintenance Alarms for Communication Manager, Media Gateways and Servers
2 of 2