Demand test descriptions and error codes - Avaya Support

Maintenance Demand Tests
External Device Alarm Query Test (#120)
The External Device Alarm Query Test determines if the Major or Minor external alarm leads
have been connected to ground, indicating an alarm condition in the adjunct equipment. The
test has no affect on the external device itself. The test environment command will report
an error against Test #120 if there is a short on one or both of the pairs of leads connecting the
external device. This test runs on the following maintenance objects:
CAUTION: Alarms
● AC-POWER
● CABINET (Cabinet Sensors)
● CARR-POW (Carrier Power Supply)
● DC-POWER (Single-Carrier Cabinet Environment)
● EMG-XFER (Emergency Transfer)
● EXT-DEV (External Device Alarm)
● POWER
! CAUTION:
can be generated on adjunct equipment, sent to the Avaya system, and
recorded and reported as "external alarms". The adjunct equipment must provide
an isolated contact closure across the alarm leads provided by the Avaya system.
The contact must be rated at a minimum of 60 V DC, with a current carrying
capacity of 5 mA minimum.
Table 329: External Device Alarm Query Test (#120) 1 of 2
Error
Code
Test
Result
Description and Recommendation
1000 ABORT Internal system error.
1. Repeat the command at one-minute intervals 1 to 3 times.
1035 ABORT The port network is not available.
1. Enter status port-network to verify that the network is not up.
2. Look for alarms against EXP-PN (Expansion Port Network),
EXP-INTF (Expansion Interface Circuit Pack), PKT-INT (Packet
Interface), etc. and resolve any problems.
1214 Maintenance Alarms for Communication Manager, Media Gateways and Servers
1 of 2