Demand test descriptions and error codes - Avaya Support

Maintenance Demand Tests
Table 289: Local Loop Test (#13) 4 of 9
Error
Code
Test
Result
Description / Recommendation
1004 ABORT The port was seized by a valid call during the test.
ADX8D-PT, ADX16D-P, DIG-LINE and E-DIG-ST:
1. Enter display port location to determine the station
extension or attendant number of the port.
2. Enter status station extension or status attendant
extension to determine the service state of the port. If the port is
in use, wait until it is idle before testing. Attendants are always in
use (off-hook) if the handset is plugged in and the port is not
busied out.
3. Retry the command at 1-minute intervals up to 5 times.
M/T-ANL:
1. To determine whether the port is in use by a valid ATMS test call,
enter status station ext where ext is the assigned ATMS
station’s number. If the port is in use, wait until it is idle.
2. Retry the command at 1-minute intervals up to 3 times.
M/T-DIG:
1. Enter list isdnpri-testcall to determine which call is using
the port (from the M/T Port column). Wait for the test call to
complete as indicated in the Start Time and Duration fields of the
above display, or abort the test call with clear
isdnpri-testcall grp#/mem# where grp#/mem# is
determined from the B-Chel field of list isdnpri-testcall.
2. Retry the command at 1-minute intervals up to 5 times.
PDMODULE and TDMODULE:
1. Enter display port location to determine the data module
extension.
2. Enter status data module extension to determine the
service state of the data module. If the data module is in use, wait
until the port is idle before retesting.
3. Retry the command at 1-minute intervals up to 5 times.
1412 ABORT This test does not run on media modules or media gateways. Ignore.
1110 Maintenance Alarms for Communication Manager, Media Gateways and Servers
4 of 9