Demand test descriptions and error codes - Avaya Support

Table 337: Loss of Signal Alarm Inquiry Test (#138) 2 of 7
Error
Code
Test
Result
Description / Recommendation
Loss of Signal Alarm Inquiry Test (#138)
1300 FAIL The CSU module/T1 sync splitter or E1 Sync Splitter is missing.
The CSU module/T1 sync splitter is missing: The Near-End CSU Type
field on the add ds1 screen has been administered as integrated but the
120A CSU module or the 401A T1 sync splitter is not physically
connected to the UDS1 board on the back of the port carrier.
1. If using the 120A CSU module or the 401A T1 sync splitter, plug the
CSU module/T1 sync splitter into the DS1/UDS1 circuit pack’s
connector on the I/O connector panel on back of the carrier.
Otherwise, set the Near-End CSU Type field to other using the
change ds1 screen.
2. Run the test again.
The E1 Sync Splitter is missing: The E1 Sync-Splitter? field on the add
ds1 screen has been administered as y but the 402A or 403A E1 Sync
Splitter is not physically connected to the UDS1 board on the back of the
port carrier.
1. If using the 402A or 403A E1 synchronization splitter, plug the E1SS
into the UDS1 circuit pack’s connector on the I/O connector panel on
back of the carrier. Otherwise, set the E1 Sync-Splitter field to n
using the change ds1 screen.
2. Run the test again.
2 of 7
Issue 5 May 2009 1239