Demand test descriptions and error codes - Avaya Support

Active-Standby Peer Link Test (#888)
Active-Standby Peer Link Test (#888)
The Active-Standby Peer Link test is run only in a system equipped with the high- or
critical-reliability configuration. It verifies that a peer link can be set up between the active and
standby PKT-INTs. A peer link is a logical connection established between the packet bus and
an IPSI circuit pack’s Packet Interface module for both active and standby IPSIs. This link
forwards data and control messages between the active and standby PKT-INT to prepare for a
pled IPSI interchange. This test checks the operation of setting up a Peer Link, and verifies that
the active and standby IPSI’s Packet Interface modules can communicate over the packet bus.
This test checks the functionality of both the active and standby Packet Interface modules, but it
is run only on the standby Packet Interface module.
This test runs on PKT-INT (Packet Interface).
Table 462: Active-Standby Peer Link Test (#888) 1 of 3
Error
Code
1006
1137
Test
Result
Description / Recommendation
ABORT An IPSI circuit pack’s Packet Interface module is out of service.
1. Enter reset packet-interface location to request a
Packet Interface module reset. See Packet Interface Reset Test
(#889).
1139 ABORT The packet bus is alarmed.
1. Enter display alarms to refer to the Alarm log and try to retire
the alarm associated with the packet bus. See PKT-BUS (Packet
Bus).
2. Retry the command when the alarm associated with the packet bus
is retired.
1335 ABORT Internal IPSI error. The Packet Interface module is on the standby IPSI.
1. Enter set ipserver-interface location to make the
standby Packet Interface active.
2. Rerun the test.
1336 ABORT Internal system error.
1. Enter set ipserver-interface location to make the
standby Packet Interface active.
2. Rerun the test.
1 of 3
Issue 5 May 2009 1537