Demand test descriptions and error codes - Avaya Support

Maintenance Demand Tests
DS1 Tie Trunk Seizure Test (#136)
The DS1 Tie Trunk Seizure Test verifies the trunk’s signaling capability. The test is composed of
two parts. The first part queries the circuit pack or media module for errors. The second part of
the test sends a seizure message to the DS1 Interface circuit pack or media module and
expects an active reply by the DS1 Interface circuit pack or media module. If the system does
not receive any reply and the timer expires, the test fails.
This second part of this test cot be run on a trunk if one of the following cases is true:
1. The trunk direction is administered as an incoming only trunk.
2. The trunk is the 24th port on a DS1 Interface circuit pack or media module which is
administered using 24th common-chel signaling.
3. The trunk has been seized by a normal trunk call.
4. The trunk is administered with maintenance test disabled.
5. The outgoing signal type of the trunk is either automatic or immediate-start.
This test runs on TIE-DS1 (DS1 Tie Trunk).
Table 336: DS1 Tie Trunk Seizure Test (#136) 1 of 3
Error
Code
Test
Result
Description / Recommendation
ABORT Internal system error
1. Retry the command at 1-minute intervals up to 5 times.
1000 ABORT System resources required to run this test were not available. The port
may be busy with a valid call.
1. Enter display port location to determine the trunk group/
member number of the port.
2. Enter status trunk to determine the service state of the port. If
the port is in use, wait until the port is idle before testing.
3. If the port status is active but the port is idle (no calls), check the
error log for Error Type 1025. See the error log table for a description
of this error and required actions for this maintenance object. The
port may be locked up.
4. If the port status is idle, retry the command at 1-minute intervals up to
5 times.
1234 Maintenance Alarms for Communication Manager, Media Gateways and Servers
1 of 3