Demand test descriptions and error codes - Avaya Support

Table 475: VC DSP Port DSP Looparound Test (#1105) 3 of 3
Error
Code
0
1
Test
Result
Description / Recommendation
FAIL The VC DSP Port DSP Loopback test failed.
1. Replace the circuit pack.
PASS The VC DSP Port DSP Loopback test passed
VC Port Reset DSP Test (#1106)
VC Port Reset DSP Test (#1106)
3 of 3
This test is destructive.
This test resets the VC DSP port and the DSP associated with it. As part of the reset procedure,
the VC DSP port runs a series of self-tests on the hardware. If these self-tests fail, the test fails.
Otherwise, the test passes.
Before executing the test, the VC DSP port must be busied out by entering busyout port
location. After the completion of the test, the VC DSP port must be released by entering
release port location.
This test runs on VC-DSPPT (Voice Conditioner DSP Port).
Table 476: VC Port Reset DSP Test (#1106) 1 of 2
Error
Code
1000
1001
Test
Result
Description / Recommendation
ABORT System resources required to run this test are not available.
The port may be busy with a call.
1. Retry the command at 1-minute intervals up to 5 times.
1015 ABORT The VC DSP port is not busied out.
1. Busyout the VC DSP port by entering busyout port location,
then retry the test.
2000 ABORT Response to the test was not received within the allowed time.
1. Retry the command at 1-minute intervals up to 5 times.
2. If this result occurs again, replace the circuit pack.
Issue 5 May 2009 1567