Demand test descriptions and error codes - Avaya Support

Table 443: Packet Neighbor Link Test (#767) 2 of 5
Error
Code
Test
Result
Description / Recommendation
Packet Neighbor Link Test (#767)
2306 ABORT The SNI circuit pack is not responding to test requests sent by software.
1. Run test led switch-node for the switch node carrier where
the SNI resides to verify whether the LEDs on the board light.
2. If the LEDs on the other boards in the carrier light, but the LEDs on
this board do not light, run test 760 using test board location
l for the active SNC in this carrier. Wait 5 minutes and then try step
1 one more time. If the LEDs on this board still do not light, replace
this board. Replacing an SNI may be service interrupting. See
SNI-BD (SNI Circuit Pack) for the procedure for replacing an SNI.
3. If none of the LEDs light for the boards in the same carrier as this
board, fix any problems associated with the connectivity of this
carrier to the server.
a. Enter list fiber-link to see the fiber connections to this
carrier.
b. Check the LEDs on every SNI and EI, and fix any fiber problems.
c. Enter display errors, and follow the repair procedures for
any EXP-INTF (Expansion Interface Circuit Pack) error entries
associated with the controlling IPSI connected PN.
d. Follow the repair procedures if there are errors for any of the
following:
● SYNC (Port Network Synchronization)
● SNI-BD (SNI Circuit Pack)
● SNC-BD (Switch Node Clock Circuit Pack)
● FIBER-LK (Fiber Link)
● SNI-PEER (SNI Peer Link)
4. Follow the Switch Node Interface Manual Loopback Procedure to
determine whether the circuit pack or the fiber connection is faulty.
2 of 5
Issue 5 May 2009 1485