Demand test descriptions and error codes - Avaya Support

Communication Manager Maintenance Object Repair Procedures
ADX8D-PT (AUDIX Digital Port)
The ADX8D-PT MO represents a port on a TN566/TN2169 EMBEDDED AUDIX circuit pack
operating in DP (digital-port) mode. The maintenance strategy for ports on the TN566 operating
in control-link mode is described in ADX16D-P (16-Port AUDIX Digital Port).
The tests apply only to switch-side maintenance that tests a circuit pack’s components related
to the TDM-bus interface. The AUDIX system has an extensive maintenance strategy that is
described in DEFINITY® AUDIX Maintenance, 585-300-110.
AUDIX resides on a combined pair of circuit packs: the TN566 MFB (multifunction board) and
the TN2169 ALB (alarm board). The 2 boards occupy 5 slots, but only 1 slot is functional as far
as the switch is concerned. The other 4 slots are seen by the switch as “AUDIX-reserved” slots
(or ADXDP-RS/ADX8D-RS).
In DP mode, the TN566 pack supports up to 8 voice ports, each with a primary and a secondary
information chel. Ports are administered in increments of two. When a call to a station with an
AUDIX login is not answered, AUDIX answers the call using one of the available voice ports.
Unlike other AUDIX systems, EMBEDDED AUDIX is not an adjunct.
CAUTION: Always
MO Name in Log Alarm Level Initial Command to Run Full Name of MO
ADX8D-PT MIN test port location l AUDIX digital port
WRN test port location
! CAUTION:
shut down AUDIX first before removing circuit packs. Follow instructions
on the TN566/TN2169 faceplate:
● Remove EMBEDDED AUDIX circuit packs
● Cycle power to a carrier containing EMBEDDED AUDIX circuit packs
● Remove power to a carrier containing EMBEDDED AUDIX circuit packs
Error log entries and recommended actions
Table 12: ADX8D-PT Error Log Entries 1 of 2
Error Type Aux
Data
Associated Test Alarm
Level
On/Off
Board
Recommended action
0 (a) 0 Any Any Any test port location
54 Maintenance Alarms for Communication Manager, Media Gateways and Servers
1 of 2