Demand test descriptions and error codes - Avaya Support

Table 527: Signaling Group Ping Test (#1387) 2 of 3
Error
Code
Signaling Group Ping Test (#1387)
7 ABORT Destination unreachable.
1. Verify that the C-LAN has been administered with an IP-Route that
enables the C-LAN to reach the far-end IP address.
2. Once verified, enter test sig-group grp# and verify that the
Signaling Group Ping test (#1387) passes.
1005 ABORT Configuration for this test is incorrect.
1. If Layer 3 or LRQ is enabled for this H.323/SIP signaling group, this
error can be ignored. There is no need to run the ping test.
2. Verify that the link is in service with status port or status
link. Verify that the routing table has destinations that are
reachable through this port.
3. Repeat the test.
4. If the test aborts with Error Code 7 after step 2 is verified, escalate
the problem.
1124
1125
ABORT Link is not in service.
1. Check if the link is in service or not. If the link is not in service,
release the link using release link or release port, and
repeat the test.
2. If the test continues to abort after the link has been released,
escalate the problem.
2000 ABORT Response to the test was not received within the allowed time.
1. If this result occurs repeatedly, attempt to reset the circuit pack if the
other ports on the board are idle (amber LED is off).
2. Rerun the test. If this result occurs again, replace the circuit pack.
2012
2100
2500
2800
2801
Test
Result
Description / Recommendation
ABORT Internal system error.
The necessary system resources to run the test could not be allocated.
Internal system error.
1. Retry the command at 1-minute intervals up to 3 times.
ABORT No C-LAN in the same region. Could not find C-LAN with this IP address.
No IP address defined.
1. Verify translations and retest.
2 of 3
Issue 5 May 2009 1661