Demand test descriptions and error codes - Avaya Support

Table 495: ATM Board Reset (#1256) 1 of 2
Error
Code
Test
Result
Description / Recommendation
ABORT Could not allocate the required system resources
1. Retry the command up to 5 times at 1-minute intervals.
2. If the test continues to abort escalate the problem.
ATM Board Reset (#1256)
1005 ABORT Wrong circuit pack configuration to run this test. The ATM CES Trunk
Interface circuit pack provides timing for the system and cot be reset
without major system disruptions.
1. Set synchronization to another ATM CES trunk circuit pack or to the
Tone-Clock circuit pack and test again.
1015 ABORT The ATM-TRK circuit pack has not been busied out.
1. Busyout out the circuit pack with busyout board location
2. Repeat the test with test board location long
1386 ABORT No Active EAL to the board. This error applies only if the board under test is
in a PN. Check the error logs for SYS-LINK (System Links) errors against
the PN where the ATM-EI resides, and take appropriate diagnostic action for
the SYS-LINK.
1407 ABORT This test cot be run on an ATM-EI board that is on the active PNC because
it cot be busied out. This error code indicates that PNC duplication is
enabled.
1. Attempt to perform a PNC interchange with
reset pnc interchange
2. If the PNC interchange is successful, busyout the original
ATM-Expansion Interface circuit pack with busyout board
location (address of the original ATM-EI board)
3. Retry the command.
2000 ABORT Did not receive the response in the allowed time.
1. Verify that the board is seen by the system with list config all.
2. If the board is visible, run the test again. If the same abort code
recurs, escalate the problem.
3. If the board is not visible to the system with list config all,
reseat the board.
4. If the board is still not recognized by the system, replace the board.
1 of 2
Issue 5 May 2009 1607