Demand test descriptions and error codes - Avaya Support

Maintenance Demand Tests
Circuit Pack Restart Test (#594)
This test is destructive.
Run this test to reset the circuit pack only if there are PPCPU errors. This test fails if the circuit
pack does not return to a sane state after being reset. The circuit pack resets through the SAKI
Sanity test (#53).
This test runs on VAL-BD (Voice announcements over LAN Circuit Pack).
Table 404: Circuit Pack Restart Test (#594)
Error
Code
Test
Result
Description / Recommendation
ABORT Could not allocate the necessary system resources to run test.
1. Retry the command at 1-minute intervals up to 5 times.
2. If the problem persists, escalate the problem.
1015 ABORT Port is not out-of-service.
1. Busyout the circuit pack with busyout board location.
2. Retry the command at 1-minute intervals up to 5 times.
3. If the problem persists, escalate the problem.
1966 ABORT The board is in the process of running the autosave command to save
announcements.
1. Retry the command again later.
2100 ABORT Could not allocate the necessary system resources to run test.
1. Retry the command at 1-minute intervals up to 5 times.
2. If the problem persists, escalate the problem.
1
2
FAIL The circuit pack failed to reset.
1. Retry the command at 1-minute intervals up to 5 times.
2. If the problem persists, pull out and reseat the circuit pack.
3. Rerun the test. If the problem persists, replace the circuit pack.
PASS The circuit pack initialized correctly.
1. Enter release board location to put the board in-service.
1382 Maintenance Alarms for Communication Manager, Media Gateways and Servers