Demand test descriptions and error codes - Avaya Support

MEDPRO-C (Media Processor Control)
MO Name in Log Alarm
Level
The TN2602AP IP Media Resource 320 provides high-capacity voice over Internet protocol
(VoIP) audio access to the switch for local stations and outside trunks. MEDPRO-C is logged in
the Event Log when:
● the TN2602AP becomes active
● the TN2602AP goes into standby
● the TN2602AP peer-link comes up or goes down
● there is a demand interchange between duplicated TN2602AP circuit packs
See IPMEDPRO (TN2602AP IP Media Resource 320) for more information on the TN2602AP.
MEDPRO-C Error Log Entries
Initial Command to Run Full Name of MO
MEDPRO-C This MO is not hardware-based. There will be
no alarms, commands to run, or tests to clear.
Events appear in display event logs.
The aux data value contains the Angel address of the TN2602AP which caused the event. For
information to map the Angel to the carrier/slot location, see EPN Angel Address/Slot Mapping.
Table 175: MEDPRO-C Error Log Entries 1 of 2
Error Type Aux Data Description
1 (a) Angel The board was taken out of service
10001 Angel No interchange, no error. No action required.
10002 Angel No interchange, no error. No action required.
10012 (b) Angel Board transition to the active state
10021 (c) Angel Board transition to the standby state
10022 (c) Angel Board transition to the active state
10031 (d) Angel Demand interchange to the standby state
10032 (d) Angel Demand interchange to the active state
612 Maintenance Alarms for Communication Manager, Media Gateways and Servers
Media Processor Control
1 of 2