Demand test descriptions and error codes - Avaya Support

Table 440: SNI-BD Configuration Audit (#759) 5 of 6
Error
Code
Test
Result
Description / Recommendation
Configuration Audit (#759)
138 FAIL The physical neighbor location does not match administered neighbor
location. The carrier and slot of the administered neighbor do not match
the carrier and slot of the physical neighbor.
1. Enter list fiber-link, and verify that the fiber-optic cable and
metallic cable connections are installed as administered.
2. If the problem does not seem to be caused by a physical connection
problem or an administration problem, replace the neighbor circuit
pack. It is possible for the neighbor circuit pack to have a hardware
problem that causes it to report a wrong Angel address (physical
carrier/slot address) to software.
139 FAIL The SNI is administered as connected to a DS1C but is not physically
connected to a DS1C.
If a DS1C should not be connected to this SNI, change administration to
remove the DS1 converter complex from the fiber link associated with this
SNI:
1. Enter list fiber-link to determine the fiber associated with the
SNI.
2. Enter remove fiber-link to remove the fiber.
3. Enter add fiber-link to add the fiber back, and do not
administer the DS1 converter complex at this time.
140 FAIL The SNI is physically connected to a DS1C but is not administered to be
connected to a DS1C.
Either add the DS1 converter complex to the fiber that this SNI is
associated with by:
1. Enter list fiber-link to determine the fiber associated with the
SNI.
2. Enter remove fiber-link to remove the fiber.
3.
Or:
Enter add fiber-link to add the fiber back, and administer the
DS1 converter complex.
4. Remove the DS1C connection, and connect the SNI directly to its
administered fiber endpoint.
5. Verify that the fiber-optic and metallic cable connections are installed
as administered by entering list fiber-link.
5 of 6
Issue 5 May 2009 1477