Demand test descriptions and error codes - Avaya Support

Maintenance Demand Tests
Table 462: Active-Standby Peer Link Test (#888) 2 of 3
Error
Code
1337 ABORT The test is not allowed to run because a PNC interchange is in progress.
A PNC interchange may have been initiated with reset pnc
interchange, or as part of a recovery action.
1. Wait 3 minutes and retry the command.
2000 ABORT Response to the test was not received within the allowed time.
2500 Internal system error
1. Retry the command at 1-minute intervals up to 3 times.
1
2
Test
Result
Description / Recommendation
FAIL Setting up peer links between the active and standby IPSI circuit pack’s
Packet Interface modules failed.
Error Code 1: The standby IPSI circuit pack’s Packet Interface module
did not respond to the peer link setup.
Error Code 2: The active IPSI circuit pack’s Packet Interface module did
not respond to the peer link setup
1. This may be the result of old firmware not supporting new software
operation. Verify the IPSI circuit pack’s firmware vintage and
download the new firmware if appropriate.
2. The firmware image on the IPSI circuit pack may have been
corrupted. Download the firmware image.
3. Retry the command.
4. If the same Error Code occurs, use display alarms to display
active alarms.
5. If there are errors related to the packet bus, see PKT-BUS (Packet
Bus) and clear those problems first.
6. Retry the test command after a 1-minute delay.
7. If the test continues to fail, replace the affected IPSI circuit pack.
PASS The server can communicate with the IPSI circuit pack’s Packet
Interface module.
1. If problems are still reported on the Packet Interface, check for
failures using the Private Looparound test (#885) and Maintenance
Looparound test (#886).
1538 Maintenance Alarms for Communication Manager, Media Gateways and Servers
2 of 3