Demand test descriptions and error codes - Avaya Support

Table 99: DS1C-BD Error Log Entries 2 of 2
Error
Type
Aux
Data
Associated Test Alarm
Level
769 (q) 7 Failure Audit test
(#949)
1281(r) Failure Audit test
(#949)
1537 (s) Failure Audit test
(#949)
1793 (t) Failure Audit test
(#949)
2049 (u) Failure Audit test
(#949)
3329 (v) Failure Audit test
(#949)
On/Off
Board
DS1C-BD (DS1 Converter Circuit Pack)
Recommended Action
MIN ON test board location
MIN OFF test board location
MAJ OFF test board location
MAJ OFF test board location
MAJ OFF test board location
WRN OFF test board location
2 of 2
Notes:
When problems persist, resetting the DS1 converter circuit pack via reset board may
temporarily resolve the error condition and restore service until further assistance is provided.
a. Error Type 0: Run the short test sequence first. If every test passes, run the long test
sequence. Refer to each test’s description, and follow its recommended procedures.
b. Error Type 1: If the alarm is on board, then a major hardware error has occurred in a
common part of the circuit pack, not circuit or packet specific. Replace the DS1 converter
circuit pack.
If the alarm is off board, then either a major hardware error has occurred in a common part
of the circuit pack, or a good clock signal cot be recovered from the synchronization
source. The synchronization source can be the fiber link or any one of the DS1 facilities.
1. Enter display errors and follow the associated repair procedures for any SYNC
(Port Network Synchronization), TDM-CLK (TDM Bus Clock), and SNC-BD (Switch
Node Clock Circuit Pack) errors.
2. Enter display errors and follow the associated repair procedures for any
FIBER-LK (Fiber Link) and DS1-FAC (DS1 Facility) errors.
3. If the problem persists, replace the DS1 converter circuit pack.
c. Error Type 18: the DS1 converter circuit pack has been busied out via busyout board.
To resolve this error, release the DS1 converter circuit pack via the release board.
Issue 5 May 2009 391