Demand test descriptions and error codes - Avaya Support

DS1 Translation Update Test (#146)
DS1 Translation Update Test (#146)
The DS1 Translation Update Test sends the board-level information specified by System
Administration to the DS1/UDS1 Interface circuit pack or media module. Translation includes
the following data (see the output of display ds1 location): DS1 Link Length between two
DS1 endpoints, Synchronization Source Control, All Zero Suppression, Framing Mode,
Signaling Mode, Time Slot Number of 697-Hz Tone, Time Slot Number of 700-Hz Tone, etc.
If a DS1/UDS1 circuit pack is combined with a 120A CSU module or the 401A T1 sync splitter to
screen an Integrated CSU module/T1 sync splitter, this test will also send the administration for
the Integrated CSU to the circuit pack to assure the board’s translations are correct. The
administration of the CSU module/T1 sync splitter is done using the DS1 Circuit Pack
administration screen. Translation for the CSU module/T1 sync splitter includes the following
data: Transmit LBO, Receive ALBO, Supply CPE Loopback Jack Power.
This test is run on the following maintenance objects:
● DS1-BD (DS1 Interface Circuit Pack)
● MAPD-BD (MAPD Interface Circuit Pack)
● MG-DS1 (DS1 Interface Media Module)
● UDS1-BD (UDS1 Interface Circuit Pack)
Table 345: DS1 Translation Update Test (#146)
Error
Code
Test
Result
Description / Recommendation
ABORT Internal system error
1. Retry the command at 1-minute intervals up to 5 times.
FAIL Internal system software error.
1. Enter display ds1 location to verify the DS1 board
translation.
2. Retry the command at 1-minute intervals up to 5 times.
PASS Translation data has been downloaded to the DS1 board successfully.
0 NO
BOARD
See NO BOARD for the repair procedures.
Issue 5 May 2009 1257