Demand test descriptions and error codes - Avaya Support

This test runs on S-SYN-PT (Speech Synthesis Port).
Table 351: Speech Synthesis DTMF Receiver Test (#163)
Error
Code
Test
Result
Description / Recommendation
Speech Synthesis DTMF Receiver Test (#163)
ABORT Could not allocate the necessary system resources to run this test.
1. Retry the command at 1-minute intervals up to 5 times.
1000 ABORT System resources required to run this test are not available. The port
may be busy with a valid call. Wait until the port is idle (amber LED is off)
before retesting.
1. If the port is idle, retry the command at 1-minute intervals up to 5
times.
2000
2100
ABORT Response to the test was not received within the allowed time.
Could not allocate the necessary system resources to run this test.
1. Retry the command at 1-minute intervals up to 5 times.
Any FAIL DTMF tones were not detected. This type of failure may cause features
using touch-tone input to the Speech Synthesis port to malfunction.
1. Verify that the Tone-Clock circuit is functioning correctly by
checking the Error Log and entering the command test
tone-clock long
2. If the test fails again, replace the Speech Synthesis circuit pack.
PASS The port has detected every DTMF tone correctly. User-reported
troubles should be investigated using other tests and by verifying other
ports on this circuit pack are working correctly.
Issue 5 May 2009 1269