Demand test descriptions and error codes - Avaya Support

A-side ATM-EI—Critical Reliability
ATM-EI (Expansion Interface Circuit Pack)
1. Remove the ATM PNC connection. See Removing ATM PNC Connections.
2. Add an ATM PNC connection. See Adding ATM PNC Connections.
B-side ATM-EI—Critical Reliability
1. Enter status pnc, and ensure that the A-PNC is active.
If not, request a pnc interchange using reset pnc interchange.
2. Enter busyout pnc-standby.
3. Enter list config carrier, and verify that an ATM circuit pack is assigned for the
new location. If not, add the ATM circuit pack’s translations.
4. Enter busyout atm pnc n (connection number) b-pnc.
5. Enter change atm pnc n (connection number) and change circuit pack location for the
B side.
6. Enter release pnc-standby.
Changing ATM Address of Standby
ATM PNC EI, Critical Reliability
1. Enter busy pnc-standby.
2. Enter change atm pnc n (connection number), and change the ATM address for the
standby side.
3. Enter release pnc-standby.
Error log entries and recommended actions
Table 34: ATM-EI Error Log Entries 1 of 3
Error
Type
Aux
Data
Associated Test Alarm
Level
On/Off
Board
Recommended Action
0 (a) 0 Any Any Any test board location
2 (b) MIN ON
18 (c) 0 busyout board
location
WRN OFF release board location
23 (d) 0 WRN OFF
125 (e) MIN ON
1 of 3
Issue 5 May 2009 129