Demand test descriptions and error codes - Avaya Support

Maintenance Demand Tests
Table 382: ISDN Test Call Test (#258) 2 of 5
Error
Code
Test
Result
Description / Recommendation
1019 ABORT Another Test call is in progress.
1. Enter list isdnpri-testcall to locate the test call.
2. Enter status isdnpri-testcall to find out the duration and
start time of the test call.
3. Enter clear isdnpri-testcall to stop the test call from
running.
4. If time and duration indicate that the test call should have stopped,
and clear isdnpri-testcall does not work, see M/T-DIG
(Maintenance/Test Digital Port) for the recommended maintenance
strategy.
1020 ABORT ATM-BCH: TN230x circuit-pack problem
1. See ATM-INTF (ATM Interface).
ISDN-TRK: There is a problem with the DS1 interface circuit pack.
1. Consult the procedures for the appropriate DS1 interface circuit
pack (DS1-BD (DS1 Interface Circuit Pack) or UDS1-BD (UDS1
Interface Circuit Pack)).
TBRI-TRK: The B-Chels are in an inconsistent state, the B-Chel does
not exist at the far-end, or the B-Chel has been rejected by the far-end.
1024 ABORT Maintenance/Test digital port in use.
1. Wait until the yellow and green LEDs on the Maintenance/Test
circuit pack are OFF.
2. Rerun the test.
3. If the problem persists, see M/T-DIG (Maintenance/Test Digital
Port).
1113 ABORT Signaling link failed
ATM-BCH, ISDN-TRK: Check the results of Signaling Link State
Audit Test (#255).
TBRI-TRK: Check the results of Signaling Link State Test (#1251).
1114 ABORT The signaling link is in a transitional state.
1. Retry the command at 1-minute intervals up to 5 times.
2. If the test continues to abort, escalate the problem.
1338 Maintenance Alarms for Communication Manager, Media Gateways and Servers
2 of 5