Demand test descriptions and error codes - Avaya Support

Table 530: Ethernet Hardware Query Test (#1405) 2 of 2
Error
Code
2012
2100
MP Diagnostic Test (#1406)
MP Diagnostic Test (#1406)
ABORT System call failed.
Could not allocate the necessary system resources to run this test.
1. Retry the command.
2801 ABORT Unable to find IP address data for this location.
1. Verify that the board is administered and rerun the test.
2807 ABORT The board is administered, but not enabled on the change
ip-interfaces form.
1. Enable the board on the change ip-interfaces form.
2. If the problem continues, replace the circuit pack.
24577
24579
24831
Test
Result
Description / Recommendation
FAIL Ethernet hardware is bad.
Ethernet hardware has been disabled by the on-board software.
On-board software detected an unknown error condition.
1. Attempt to reset the circuit pack.
2. Rerun the test. If the problem continues, replace the circuit pack.
PASS Communication with this circuit pack is successful.
This test is destructive.
The MP Diagnostic Test runs the following diagnostic tests in the following order, but only if
each successive test passes:
DSP FPGA Query: This test verifies the status of the FPGA device on the TN2302 circuit pack.
If the device is bad, the system posts an error and alarm and takes out of service every DSP
that is controlled by the one FPGA. The system then attempts to reset the FPGA. If the reset
passes or the original test passes, the DSPs are placed back into service.
Ethernet Query: This test passes if the TN2302 hardware is functioning properly and the
Ethernet port is connected. Otherwise, it fails.
2 of 2
Issue 5 May 2009 1665