Demand test descriptions and error codes - Avaya Support

Maintenance Demand Tests
Clock Health Inquiry Test (#46)
The Clock Health Inquiry Test reads special data stored in memory to determine if the IPSI or
Tone-Clock circuit pack had a loss of any of three clock types:
● SYSCLK
● SYSFM
● SYSDCLK
If this data indicates this IPSI or Tone-Clock circuit pack had a loss of any of these clocks, the
test fails. TDM-CLK Error 1 indicates a suspect clock is at the edge of its specified frequency. If
the circuit pack did not have a loss of clock, the test passes.
This is not really a test, in the sense that it simply reports status held by the system, and does
not generate new information or raise alarms. If this test fails with no Error Code, there is at
least one Major alarm against an IPSI or Tone-Clock circuit pack. If this test fails with an Error
Code of 1, there is at least one Minor off-board alarm against a TDM-CLK.
This test runs on the following maintenance objects:
● TDM-CLK (TDM Bus Clock)
● TONE-BD (Tone-Clock Circuit Pack)
● TONE-PT (Tone Generator)
Table 299: Clock Health Inquiry Test (#46) 1 of 2
Error
Code
Test
Result
Description / Recommendation
ABORT Internal system error.
Retry the command at 11-minute intervals up to 5 times.
1412 ABORT This test does not run on media modules or media gateways. Ignore.
1144 Maintenance Alarms for Communication Manager, Media Gateways and Servers
1 of 2