Demand test descriptions and error codes - Avaya Support

Table 522: DSP Port TDM Looparound Test (#1380) 2 of 2
Error
Code
2000
2100
2500
Test
Result
Windows 2000 Reset Test (#1381)
Windows 2000 Reset Test (#1381)
ABORT Response to the test was not received in the allowed time.
Could not allocate the necessary system resources to run this test.
Internal system error.
1. Retry the command at 1-minute intervals up to 3 times.
2801 ABORT The TN802B/TN2302 Media Processor board has not been administered
on the ip-interfaces screen.
ANY FAIL The test did not detect the test tone through the looparound connection.
1. Test the tone-clock in the port network that contains the media
processor under test.
2. If the tone-clock is healthy, test the media processor board again.
3. If the test continues to fail, replace the media processor board.
PASS The board is functioning properly.
0 NO
BOARD
Description / Recommendation
See NO BOARD for repair procedures.
This test resets the TN802 MAPD circuit pack. The test is highly destructive and can be
initiated only by a reset board location command on the TN802 circuit pack.
This test runs on MEDPRO (Media Processor MAPD Circuit Pack).
Table 523: Windows 2000 Reset Test (#1381) 1 of 2
Error
Code
Test
Result
Description / Recommendation
ABORT System resources required for this test are not available.
1. Retry reset board location at 1-minute intervals up to 5
times.
2 of 2
1 of 2
Issue 5 May 2009 1655