Demand test descriptions and error codes - Avaya Support

● Be administered using the add ds1 location command
MG-DS1 (DS1 Interface Media Module)
● Be physically inserted into the correct slot
If the Media Module has an entry in the circuit plan and either of the other two conditions
are not met, a MINOR alarm is logged.
1. To resolve the error do either of the following:
● Make sure that all conditions for administration are met and that a functioning
Media Module is inserted in the correct slot.
● Completely remove the Media Module from the system using the following steps.
2. Remove any administered DS1 trunks, access endpoints or PRI endpoints associated
with the Media Module from their trunk groups.
3. Execute remove ds1 location and change media module location.
c. Error Type 18: the Media Module has been busied out by a busyout board location
command. Release the Media Module with the command release board location.
d. Error Type 23: the Media Module is not completely administered. To be fully administered,
the Media Module must:
● Have an entry in the circuit plan using the change media module command
● Be administered using the add ds1 location command
● Be physically inserted into the correct slot
A DS1 Media Module differs from most Media Modules in that inserting the DS1 Media
Module into the media gateway is not enough to make the board usable. It must also be
administered with the add ds1 command.
e. Error Type 125: An incorrect Media Module is inserted in the slot where the Media Module
is logically administered.
To resolve this problem, either:
● Remove the incorrect Media Module and insert the logically administered Media
Module.
● Use the change circuit-pack command to re-administer this slot to match the
Media Module inserted.
f. Error Type 257: Refer to Control Chel Looparound Test (#52) for details.
g. Error Type 513: the Media Module has detected a transient hardware problem.
The value in the Aux Data field indicates the type of hardware problem:
Aux Data 4352: External RAM failure
Aux Data 4353: Internal RAM failure
Aux Data 4355 Internal ROM failure
If the board detects only one of these hardware problems, the error will disappear when
none of these faults are detected for 10 minutes. If the same Aux Data value is logged
more than once in a 24 hour period, the Media Module should be replaced.
Issue 5 May 2009 641